JK Door Hinge Flag Covers: Easy Installation Tips

Quick Answer

Installing US flag door hinge covers on your Jeep Wrangler JK is a straightforward DIY project that takes about 30 minutes. Follow these steps for a secure, long-lasting fit.

Installation Steps

1. 1. Clean the Hinge Surface: Thoroughly clean the existing door hinges with isopropyl alcohol to remove dirt, wax, and oils. Let the surface dry completely. Common mistake: Skipping this step can prevent the adhesive from bonding properly.
2. 2. Dry-Fit the Covers: Hold each cover (inner and outer) against the corresponding hinge without removing the backing. Check alignment and ensure they match your door configuration (2-door or 4-door). Checkpoint: The covers are pre-cut for a perfect fit, but verify orientation before peeling the backing.
3. 3. Apply the Covers: Peel the backing from one cover, align it carefully, and press firmly onto the hinge. Apply even pressure across the entire surface for about 30 seconds. Common mistake: Rushing the pressing step can lead to air bubbles or weak adhesion.
4. 4. Repeat for Remaining Hinges: Install the remaining covers (inner and outer for each door) using the same process. Wait at least 24 hours before washing your Jeep or exposing it to heavy rain. Checkpoint: The adhesive reaches full strength after 24 hours, so avoid pressure washing or car washes during this period.

Product Details

• For Jeep Wrangler JK 2007-2018 US Flag Inner &Outler Car Door Hinge Original Accessories 2/4-Door: Three layers of high-quality UV and scratch-resistant polyurethane gloss coating ensure permanent good looks. This coating protects the flag design from fading and scratching, keeping your Jeep looking sharp for years.