Jeep Wrangler JL Gladiator JT Dashboard Air Vent Cover Trim Install

By RT-TCZ : Accessories, Parts & Trim for Jeep | Published: 2026-10-27

Category: How-to Guides

Step-by-step guide to installing side vent outlet covers on your 2024+ Jeep Wrangler JL or Gladiator JT dashboard. Tips for a secure, lasting fit.

Quick answer

Installing a dashboard air vent cover trim on your 2024+ Jeep Wrangler JL or Gladiator JT is a simple DIY job using double-sided tape. Clean the surface, test the fit, then press firmly for a lasting bond.

Why this trim upgrade matters

The factory side vent outlets on the JL and JT dashboard are functional but plain. Adding a trim cover gives the interior a more finished, premium look without replacing the entire vent assembly. The covers are designed with laser-cut precision to match the dashboard contours, so they blend in rather than look stuck on.

What to watch for before you start

Surface preparation is the most common reason these trims fail to stay attached. Dust, grease, or residue from protectants can weaken the adhesive. Also, avoid installing in very cold temperatures—below 50°F (10°C)—because the tape needs warmth to bond properly. If you must install in cooler weather, warm the trim and the dashboard area with a hairdryer on low heat first.

Installation steps

Clean the dashboard surface: Wipe the area around both side vent outlets with isopropyl alcohol (70% or higher) on a lint-free cloth. Remove any dust, wax, or Armor All residue. Let it dry completely for 2–3 minutes. Skipping this step is the #1 cause of trims peeling off later. If the cloth shows any dirt, wipe again.
Dry-fit the trim cover: Hold the trim piece over the vent outlet without removing the tape backing. Check that the cutouts align with the vent slats and the edges sit flush against the dashboard. If it rocks or gaps, reposition until it sits flat. Once the tape touches the surface, repositioning is difficult. Confirm alignment now.
Peel and press: Remove the red backing from the double-sided tape. Starting from one edge, press the trim onto the dashboard. Apply firm, even pressure across the entire piece for 30–60 seconds. Use your thumb to work around the vent slats. Don't press so hard that you dent the trim. Even pressure is better than one hard push.
Allow the bond to set: Leave the vehicle parked for at least 24 hours before washing or exposing it to direct sun. The adhesive reaches full strength after a day of curing at room temperature. If you drive immediately, avoid hitting potholes or bumps that could jostle the trim loose.

Product details

For 2024+ Jeep Wrangler JL & Gladiator JT Dashboard Panel Both Side Air Vent Outlet Cover Trim: Three layers of high-quality UV and scratch-resistant polyurethane gloss coating. The coating protects the trim from sun damage and everyday scuffs, so it keeps its shine even after months of exposure through the windshield.
For 2024+ Jeep Wrangler JL & Gladiator JT Dashboard Panel Both Side Air Vent Outlet Cover Trim