Jeep JL & Gladiator Dash Rail Phone Mount: Install Guide

By RT-TCZ : Accessories, Parts & Trim for Jeep | Published: 2026-10-31

Category: How-to Guides

Mount a phone holder on the 2024+ Jeep JL and Gladiator JT center console dash rail without drilling. Follow these steps to remove the grab bar, align the bracket, and keep the phone secure on rough trails.

Quick answer

For a 2024+ Jeep Wrangler JL or Gladiator JT, mount the phone holder on the center console dash rail by removing the grab bar, sliding the bolt-on bracket into the rail, and tightening it down—no drilling required.

Why the dash rail is a better mounting point than the windshield

A dash rail mount keeps the phone within easy reach and sightline without blocking the windshield or venting. On the 2024+ JL and JT, the rail sits on the center console, so you can route a charging cable down the console instead of across the dash. The trade-off is that the rail is a shared space: if you already use it for a dash tray or other accessories, you may need to reposition them to make room for the phone bracket.

Check your rail and bracket before you start

The RT-TCZ bracket is listed for 2024+ Jeep Wrangler JL and Gladiator JT, and it uses the existing grab bar and rail—no drilling. Before removing anything, confirm your Jeep has the center console dash rail and that the bracket’s clamp matches the rail width. The product page does not list a maximum phone size or a specific rail diameter, so test-fit the bracket and check that your phone (with case) fits the holder’s jaws before you tighten everything down.

Step-by-step installation

Remove the grab bar: Unscrew the grab bar fasteners by hand or with a trim tool, then lift the bar away from the center console. Keep the screws in a cup so they don’t roll into the console. Checkpoint: the rail should now be exposed and free of loose trim clips.
Slide the bracket onto the rail: Open the bracket clamp and slide it onto the exposed rail from the end. Position it where the phone won’t block the console controls or your view of the dash. Common mistake: forcing the clamp over the rail can scratch the finish—loosen the clamp screw first.
Tighten the clamp: Hand-tighten the clamp screw until the bracket grips the rail firmly. Do not overtighten; the bracket should not slide when you push it side to side. Checkpoint: give the bracket a firm wiggle—any movement means it needs another quarter turn.
Reinstall the grab bar: Refit the grab bar over the rail and start the fasteners by hand. Tighten them evenly, alternating sides so the bar seats flush. Common mistake: overtightening one screw first can strip the plastic threads—snug them in stages.
Attach and adjust the phone holder: Clip or bolt the phone holder to the bracket, then set the viewing angle. With the phone in place, check that the holder’s jaws grip the sides of the phone and that the charging port stays accessible. Checkpoint: the phone should not wobble when you tap the screen.
Test on a rough surface: Before a trail run, drive over a speed bump or rough pavement and watch the phone. If it shifts, tighten the clamp and the holder joint, or reposition the bracket closer to the grab bar for more support. If the phone still moves, check that the holder’s jaws are sized for your phone case—not all cases fit the same.

Product facts

For 2024+ Jeep Wrangler JL & Gladiator JT Interior Center Console Dashboard Rail Expansion Phone Holder Mount: Fits 2024+ Jeep Wrangler JL and Gladiator JT; made of ABS and aluminum alloy/iron; bolt-on installation with no drilling required. The bolt-on design means you can install it with basic hand tools and remove it without leaving holes in the dash.
For 2024+ Jeep Wrangler JL & Gladiator JT Interior Center Console Dashboard Rail Expansion Phone Holder Mount