Jeep JK Ignition Ring Cover Trim Install Guide

Quick Answer

Installing a Jeep Wrangler JK ignition ring cover trim takes about 10 minutes and requires no special tools. The key is proper surface prep and alignment before pressing the adhesive.

Installation Steps

1. 1. Clean the Ignition Bezel Area: Wipe the steering column and ignition bezel with isopropyl alcohol. Remove all dirt, oil, and wax residue. Let it dry completely for 2 minutes. Common mistake: skipping this step causes poor adhesion. Even a small grease spot can make the trim fall off.
2. 2. Test-Fit the Trim Ring: Hold the trim ring over the ignition switch without removing the adhesive backing. Align it so the opening centers on the key slot. Check that it does not interfere with the key turning or the steering column stalk. Checkpoint: if the ring rubs the key or column, adjust position before peeling the backing.
3. 3. Peel and Press the Adhesive: Peel the double-sided tape backing. Press the ring firmly onto the bezel, starting from the top center and working outward. Apply even pressure for 30 seconds. Common mistake: pressing only the edges leaves the center loose. Use a credit card wrapped in a microfiber cloth to burnish the entire surface.
4. 4. Let the Adhesive Cure: Avoid washing the car or exposing the trim to rain for 24 hours. The adhesive reaches full bond strength after a day. Checkpoint: if you must drive in rain, cover the trim with painter's tape for the first day.

Product Details

• For Jeep Wrangler JK 07-18 /Compass 07-16/ Patriot 11-16 Ignition Switch Ring Cover Trim: Three layers of high-quality UV and scratch-resistant polyurethane gloss coating ensure permanent good looks. The coating protects the trim from sun fading and key scratches, keeping it looking new for years.