What This Guide Covers
If you own a 2007-2018 Jeep Wrangler JK or JKU, upgrading the headlight trim bezels is a quick way to refresh the front-end look. These bezels are designed to fit your factory headlights with a simple adhesive installation. This guide walks through fitment, preparation, installation steps, and care tips so you can get the job done right.
Fitment: Which Models Work
The trim bezels are made for 2007-2018 Jeep Wrangler JK and JKU models (two-door and four-door). They are not confirmed for other Jeep generations or models. The bezels are crafted from ABS plastic with laser-cut precision to match the headlight housing contour. A super-strong adhesive backing holds them in place without drilling or permanent modification.
Product at a Glance
- For 2007-2018 Jeep Wrangler JK JKU Headlight Trim Bezels: Made of high-quality ABS material with UV and scratch-resistant polyurethane gloss coating. The coating helps the trim resist fading and scratching from sun and road debris, keeping the bezels looking good longer.

For 2007-2018 Jeep Wrangler JK JKU Headlight Trim Bezels - For 2007-2018 Jeep Wrangler JK JKU Headlight Trim Bezels: Easy DIY installation with double-sided tape; no tools required. You can install these bezels in minutes without special skills or equipment, making it an accessible upgrade for any owner.
- For 2007-2018 Jeep Wrangler JK JKU Headlight Trim Bezels: Available in 11 colors: Black, Red, Chrome, Pink, Yellow, White, Green, Orange, Purple, Light Blue, Blue. You can match or contrast your Jeep's paint or trim, adding a personal touch to the front end.
Installation Steps as Supplied
Follow these steps for a secure bond. The supplied instructions cover the key points.
- Clean the installation area: Wipe the headlight housing surface thoroughly. It must be dry and free of dust, wax, or grease for the adhesive to stick.
- Tear off the self-adhesive backing: Remove the protective film from the double-sided tape on the back of the bezel. Avoid touching the adhesive with your fingers.
- Heat the adhesive if needed: If the ambient temperature is below 59°F, warm the adhesive with a hairdryer for better bonding. Do not overheat the plastic.
- Press the bezel into place: Align the bezel with the headlight opening and press firmly along the entire edge. Hold for the duration recommended in the product instructions to ensure initial contact.
- Do not wash the car for 48 hours: Avoid car washes or heavy rain exposure for 48 hours after installation so the adhesive can fully cure.
Removal and Adjustments
The bezels can be removed without leaving glue residue. If you want to change colors or remove the trim, you can simply peel it off. The supplied information says no glue will be left, or any residue can be erased. If a bezel falls off on some car models, the manufacturer notes you can add extra tape and reattach it.
What the Listing Does Not Cover
The listing does not confirm compatibility with aftermarket headlights or LED housings. If your Jeep has non-factory lights, measure the bezel opening before ordering. The bezels are cosmetic covers, not replacements for broken or damaged headlight housings. The supplied evidence does not include a warranty beyond the 1-year manufacturer warranty, nor does it specify maximum temperature tolerance or impact resistance.


