Before you peel any tape
The RT-TCZ door sill guards are made for 2018 and newer Jeep Wrangler JLU and Gladiator JT four-door models. They are not a universal trim piece, so confirm your Jeep is a four-door before ordering. The set includes four guards and uses double-sided tape for a DIY installation.
The guards are made of ABS with a UV- and scratch-resistant polyurethane gloss coating. The listing notes that laser cutting is used to achieve a precise fit for these models. Because the fit is vehicle-specific, the most important preparation step is making sure the sill area is clean, dry, and free of dust before you begin.
What the RT-TCZ set includes
- For 2018+ Jeep Wrangler JLU &Gladiator JT 4Doors Door Sill Guards Entry Guards Cover: Package includes 4PCS Door Sill Guards. You get one guard for each of the four doors on your JLU or JT.

For 2018+ Jeep Wrangler JLU &Gladiator JT 4Doors Door Sill Guards Entry Guards Cover - For 2018+ Jeep Wrangler JLU &Gladiator JT 4Doors Door Sill Guards Entry Guards Cover: Material: ABS. A rigid plastic guard that is shaped to the sill contour.
- For 2018+ Jeep Wrangler JLU &Gladiator JT 4Doors Door Sill Guards Entry Guards Cover: Manufacturer Warranty: 1 Year. Gives you a defined coverage period for defects.
Installation steps from the supplied guide
The listing provides a short installation sequence. Follow it in order, and work on one door at a time so you can keep the adhesive clean.
- Step 1: Clean and dry the sill: Clean the installation area and keep it dry and free of dust. A clean surface is essential for the tape to bond.
- Step 2: Peel the self-adhesive backing: Tear off the self-adhesive on the back of the guard. Avoid touching the exposed tape.
- Step 3: Warm the adhesive in cold weather: If the weather is below 15 degrees, you may need to heat the self-adhesive with a hairdryer for better adhesion. The listing does not specify Celsius or Fahrenheit, so use your judgment for your local climate.
- Step 4: Press the guard into place: Align the guard with the sill and press firmly. The laser-cut design is intended to fit the contours of your Jeep.
- Step 5: Wait 48 hours before washing: Do not wash the car within 48 hours after installation. This allows the adhesive to fully set.
If a guard lifts later
The listing notes that in case a guard falls off for some car models, you can add some tape and put the cover back on. It does not specify a tape type, so use a suitable double-sided automotive tape. The 1-year manufacturer warranty may cover defects, but it does not promise that the adhesive will never fail.
If you need to remove a guard, the listing says it can be removed easily without leaving glue, or you can erase any residue. This makes the guards a reversible addition if you change your mind.
Black A or Black B: choose before you install
The guards are available in two color options, Black A and Black B. The listing does not describe the difference between them, so check the product images to decide which look you prefer. Once the tape is applied, switching colors means removing and reinstalling, so pick your finish first.
- Black A: One of two black finish options.
- Black B: The other black finish option.
Care that protects the bond and the finish
After the first 48 hours, normal washing is fine, but avoid directing a high-pressure spray directly at the edges of the guards. The polyurethane gloss coating is UV- and scratch-resistant, but abrasive cleaners or rough cloths can dull the finish over time. A soft cloth and mild soap are all you need.
Because the guards are ABS plastic with a gloss coating, they can be cleaned with the same products you use on other exterior trim. Avoid solvents or harsh chemicals that could attack the coating or the adhesive.


